User manual WHIRLPOOL SPA1040 INSTALLATION

DON'T FORGET : ALWAYS READ THE USER GUIDE BEFORE BUYING !!!

If this document matches the user guide, instructions manual or user manual, feature sets, schematics you are looking for, download it now. Diplodocs provides you a fast and easy access to the user manual WHIRLPOOL SPA1040. We hope that this WHIRLPOOL SPA1040 user guide will be useful to you.


WHIRLPOOL SPA1040 INSTALLATION: Download the complete user guide (732 Ko)

You may also download the following manuals related to this product:

   WHIRLPOOL SPA1040 PRODUCT DATA SHEET (352 ko)
   WHIRLPOOL SPA1040 TABELA DE PROGRAMAS (2663 ko)
   WHIRLPOOL SPA1040 ETIQUETA ENERGÉTICA (146 ko)
   WHIRLPOOL SPA1040 MANUAL DE INSTRUÇÕES (268 ko)
   WHIRLPOOL SPA1040 INFORMAÇÃO DE PRODUTO (63 ko)

Manual abstract: user guide WHIRLPOOL SPA1040INSTALLATION

Detailed instructions for use are in the User's Guide.

[. . . ] € Read the general recommendations about disposing of packaging in the Instructions for Use. Lada) Inlet hose (inside the machine or already installed) Conector en Y (sólo con algunos modelos) Adaptador em Y (apenas fornecido com certos modelos) Adaptador en forma d’Y (només inclòs en determinats models) Y-adapter (only supplied for certain models) 2 - Si no se quitan los pernos de transporte, el aparato puede sufrir daños. [. . . ] - Important: tighten the locknut by turning it counterclockwise against the appliance cabinet. - If the water inlet hose is not already installed, it must be screwed to the appliance. If your washing machine has one inlet valve on the back: connect it to cold fill only. Entrada d’aigua freda Entrada d’aigua calenta Vàlvula d’entrada blava Vàlvula d’entrada vermella Entrada d’aigua freda Adaptador en forma d’Y Cold fill Hot fill - If your washing machine has two inlet valves on the back, you must connect both valves to the water supply: • either connect red inlet valve to hot fill tap and blue inlet valve to cold fill tap • or connect both inlet valves to cold water tap by using a Y-adapter. Screw the inlet hose by hand to the tap and to the inlet valve and tighten the nut. € The appliance must not be connected to the mixing tap of an un-pressurized water heater. € Check water-tightness of connections by turning the tap completely on. € If the hose is too short, replace it with a suitable length of pressure resistant hose (1000 kPa min, EN 50084 approved type). € Check the inlet hose regularly for brittleness and cracks and replace if necessary. - For models with Water Stop hose: If the flexible hose is too short, replace it with a longer Water Stop hose available through our After-Sales Service or from your dealer. [. . . ] The electrical power cable must be replaced exclusively by a licensed electrician. Electrical connections in your home must correspond to the valid local regulations. [. . . ]

DISCLAIMER TO DOWNLOAD THE USER GUIDE WHIRLPOOL SPA1040




Click on "Download the user Manual" at the end of this Contract if you accept its terms, the downloading of the manual WHIRLPOOL SPA1040 will begin.

 

Copyright © 2015 - manualRetreiver - All Rights Reserved.
Designated trademarks and brands are the property of their respective owners.