User manual WHIRLPOOL W8TXNWFBB ENERGY GUIDE

DON'T FORGET : ALWAYS READ THE USER GUIDE BEFORE BUYING !!!

If this document matches the user guide, instructions manual or user manual, feature sets, schematics you are looking for, download it now. Diplodocs provides you a fast and easy access to the user manual WHIRLPOOL W8TXNWFBB. We hope that this WHIRLPOOL W8TXNWFBB user guide will be useful to you.


WHIRLPOOL W8TXNWFBB ENERGY GUIDE: Download the complete user guide (1647 Ko)

You may also download the following manuals related to this product:

   WHIRLPOOL W8TXNWFBB DIMENSION GUIDE (87 ko)
   WHIRLPOOL W8TXNWFBB USE & CARE GUIDE (1299 ko)
   WHIRLPOOL W8TXNWFBB WARRANTY INFORMATION (101 ko)

Manual abstract: user guide WHIRLPOOL W8TXNWFBBENERGY GUIDE

Detailed instructions for use are in the User's Guide.

[. . . ] Complete and mail the Product Registration Card or register online at www. U-LineService. com. Once your unit is installed, keep the Use and Care Guide and this Installation Guide in a safe place for future reference. Black and White units have a reversible door with a slightly contoured handle across the top. Stainless Steel units are covered with a protective coating and have been ordered left- or right-hand hinged. [. . . ] A final finish coat was not applied so that the wood trim could be stained to match décor or overlay frame. 2115WCOL Models are designed for, and require installation of, an Overlay Frame. If none of these treatments are to be included in this installation, go on to 5 Adjust Door. CAUTION To prevent permanent damage to the inner liner of the Wine Captain®, the wine rack wood trim MUST be removed from the unit for staining and/or finishing. Allow stain/finish to dry thoroughly (at least 24 hours per coat) in accordance with the stain/finish manufacturer's instructions prior to re-installing the wood trim inside the cabinet of the Wine Captain®. Failure to do so may cause the inner liner of the unit to have a permanent odor, which is not covered by the warranty. Wine Rack Removal/Installation To remove a rack from the cabinet: 1. Remove any bottles stored on the rack. 23-1/4" 34-1/4" to 35-1/8" 7" 1/4" Space Between Appliances 1" Figure 11 Figure 12 ULIN_0207_A 3. A low odor, water clean up, quick-drying finish such as Minwax® Polycrylic® Protective Finish is recommended (Minwax® Polycrylic® is an ultra fastdrying water-based finish). Apply a thin coat of a clear, protective finish, following the container label directions. Allow the final coat to dry for 24 hours before reinstalling the trim to the cabinet interior components. Wood Trim Finishing Interior components of your U-Line unit are equipped with a natural wood trim for appearance and durability. Although this wood trim has been coated with a clear sealer at the factory, it is recommended that the trim be stained (if desired), and receive a final finish coating prior to the unit going into full-time service. WARNING To prevent permanent damage to the inner liner of your unit, the wood trim MUST be removed from the unit for staining and/or finishing. Allow stain/finish to dry thoroughly (at least 24 hours per coat) in accordance with the product manufacturer's instructions prior to reinstallation. 0. 177" diameter (#16 drill) x 11/16" deep Incorrect Correct 6. Cut foam tape into four pieces, two pieces the width of the overlay frame and two pieces the height of the overlay frame. Remove the adhesive protection strip from one piece of the foam tape and align to the edge of the overlay frame as shown in Figure 18, adhering the foam tape to the overlay frame. Damage to the overlay frame can occur if the foam tape is not trimmed properly. CAUTION It is important to ensure that all drilled holes are drilled to the correct depth in order to avoid splits in the wood when hardware is installed. Installation Instructions Preparing Door Gasket Note: Door is not attached. Start in the Figure 16 middle and pull outward, moving toward the edge (see Figure 16). This may take some force. Typical Wood Frame Top Pivot Plate 8 mm Plug Insert Two Required #6 X 5/8" Flat Head Screw Two Required Note: Lay gasket flat on a clean surface to avoid disturbing interior magnet. Use two #6 screws to attach top pivot bracket to the overlay frame (see Figure 19). If a user-supplied cabinet handle will be used, attach its hardware to the overlay frame at this time. Not Fully Seated Little or No Gap Objectional Gap Figure 17 1. See Figure 17. www. U-LineService. com 10 06/2006 2115WC/2115WCOL Wine Captain® IMPORTANT User-supplied cabinet handle MUST be counter bored to make sure mounting hardware is below surface of overlay frame. Overlay frame will not sit flush to door if mounting hardware is not counter bored. Note: The door frame is designed with a slight amount of "play" to square it to the overlay frame. Starting at the corners and working toward the center, push the door gasket back into place. [. . . ] Level should be placed along top edge and side edge as shown (see Figure 28). Figure 28 ULIN_0206_A 2. If the Wine Captain® is not level, adjust the feet on the corners of the unit as necessary (see Figure 29). 23-1/4" 7" Turn Foot to Adjust 1" Figure 29 3. Check the levelness after each adjustment and repeat the previous steps until the unit is level. Go on to 8 Install the Unit. Figure 27 WARNING SHOCK HAZARD -- Electrical Grounding Required. [. . . ]

DISCLAIMER TO DOWNLOAD THE USER GUIDE WHIRLPOOL W8TXNWFBB




Click on "Download the user Manual" at the end of this Contract if you accept its terms, the downloading of the manual WHIRLPOOL W8TXNWFBB will begin.

 

Copyright © 2015 - manualRetreiver - All Rights Reserved.
Designated trademarks and brands are the property of their respective owners.