User manual WHIRLPOOL WOS97ES0ES INSTALLATION GUIDE

[. . . ] W10777368B BUILT-IN OVEN SAFETY Your safety and the safety of others are very important. We have provided many important safety messages in this manual and on your appliance. This symbol alerts you to potential hazards that can kill or hurt you and others. All safety messages will follow the safety alert symbol and either the word “DANGER” or “WARNING. [. . . ] R Remember to keep the corner posts and other materials that may be needed for installation. Remove the hardware package from inside the bag containing literature.  rior to removing the oven door, prepare a surface where P you will place it. This surface should be flat and covered with a soft blanket, or use the corner posts from your packaging material.  ocate the oven door hinge locks in both corners of the oven L door, and then rotate the hinge locks toward the oven door to the unlocked position. If the door hinge lock is not rotated fully (see illustration B), the door will not remove properly.  the oven door(s) aside on the prepared covered work Set surface, with the oven door resting on its handle.  continue with the oven installation, go to the “Positioning To Oven Feet for Multiple Cabinet Cutout Heights” section.  ocate the slots on each side of the oven cavity for the door L hinge locks.  a 45° angle, align door hinges with slots in the lower At front of the oven cavity. Slowly insert door, making sure you maintain the 45° angle. You will know the door is engaged in the slot when you feel a slight drop. Positioning Oven Feet for Multiple Cabinet Cutout Heights Single Ovens The positioning of the oven feet allow a single oven to be installed in a cutout height between 2615⁄16" and 297⁄16" (68. Refer to the following instructions to position the feet for the size of your cabinet cutout. If the oven door does not open to a full 90°, repeat steps 1 through 3.  Locate the oven door hinge locks in the corners of the oven door, and rotate the hinge locks toward the oven cavity to the locked position.  See Step 3 (illustration A) in the “Remove Oven Door(s)” section for proper locked position.  When the hinges are properly installed and the door closed, there should be an even gap between the door and the control panel. If one side of the oven door is hanging lower than the other, the hinge on that side is not properly installed. Using 2 or more people, place the oven on its back on a covered surface. Using 2 or more people, place the oven on its back on a covered surface. Remove the foot from the right front spacer by removing the #8-18 x ³⁄8" screw. [. . . ]  he bottom vent and bottom vent trim (required when the T oven is installed with the feet in the tall position) are shipped in the foam packing at the top of the oven. To install both the bottom vent and the bottom vent trim for installations with the feet in the tall position, see the instructions in Step 6. A ■  sing one #8-18 x ³⁄8" screw (D) on each side of the vent U ■  lign vent tab (B) with oven frame (A) as shown. A ■  sing one #8-18 x ³⁄8" screw (E) on each side of the vent U tab (B), fasten the vent securely to the oven. [. . . ]