User manual WHIRLPOOL WTW8000BW INSTALLATION GUIDE

DON'T FORGET : ALWAYS READ THE USER GUIDE BEFORE BUYING !!!

If this document matches the user guide, instructions manual or user manual, feature sets, schematics you are looking for, download it now. Diplodocs provides you a fast and easy access to the user manual WHIRLPOOL WTW8000BW. We hope that this WHIRLPOOL WTW8000BW user guide will be useful to you.


WHIRLPOOL WTW8000BW INSTALLATION GUIDE: Download the complete user guide (4702 Ko)

You may also download the following manuals related to this product:

   WHIRLPOOL WTW8000BW (5100 ko)
   WHIRLPOOL WTW8000BW (5100 ko)
   WHIRLPOOL WTW8000BW DIMENSION GUIDE (493 ko)

Manual abstract: user guide WHIRLPOOL WTW8000BWINSTALLATION GUIDE

Detailed instructions for use are in the User's Guide.

[. . . ] Some water can remain in washer and can cause damage in low temperatures. See your “Use and Care Guide” for information on winterizing. If you have: Laundry tub or standpipe taller than 96" (2. [. . . ] Then, set washer back upright, and remove the tape from the lid so that you can open the lid and remove the foam packing ring from the washer tub. INSTALLATION INSTRUCTIONS NOTE: Keep foam packing ring in case you need to move the washer in the future. CONNECT DRAIN HOSE IMPORTANT: Proper connection of the drain hose helps to avoid water leakage and damage to your floors. The drain hose is connected to your washer and is stored inside the washer cabinet. It is necessary to remove all shipping materials for proper operation and to avoid excessive noise from washer. NOTE: To avoid floor damage during installation, set the washer onto cardboard before moving across the floor. IMPORTANT: ■■ Be sure the foam shipping base has been removed from the bottom of the washer as directed in the “Remove Shipping Base and Packing Ring” section. –■ If foam shipping base has not been removed, be sure lid is 1. Remove drain hose from washer cabinet secured with tape before laying washer on its back. –■ Removing the foam shipping base is necessary for proper Gently pull hose out of back of washer cabinet from top until end emerges. Washer B IMPORTANT: To avoid leaks, check that your water inlet For a laundry tub or standpipe drain, connect the drain hose form. Bend hose and feed through other side, anchoring form on smooth sections of hose. Washer must be connected to water faucets with new inlet hoses with flat washers (not provided). IMPORTANT: To keep drain water from going back into the washer: ■■ Do not force excess drain hose into standpipe. –■ Do not lay excess hose on the bottom of the laundry Make sure the washer basket is empty. Repeat this step with the hose labeled cold for the cold water faucet. [. . . ] Adjust the feet if necessary, then using the wrench again, turn the locknuts counterclockwise on the foot to tighten to the washer cabinet. HELPFUL TIP: You may have to adjust the back feet to level the washer. If you are installing the washer in a tight or hard-to-reach area, you may have to move the washer out to reach the feet comfortably. [. . . ]

DISCLAIMER TO DOWNLOAD THE USER GUIDE WHIRLPOOL WTW8000BW




Click on "Download the user Manual" at the end of this Contract if you accept its terms, the downloading of the manual WHIRLPOOL WTW8000BW will begin.

 

Copyright © 2015 - manualRetreiver - All Rights Reserved.
Designated trademarks and brands are the property of their respective owners.