User manual ZONET ZEN3200 QUICK INSTALLATION GUIDE

[. . . ] 10/100Mbps Fast Ethernet Adapter Quick Installation Guide Introduction: Congratulation on your purchase of the Zonet ZEN3200 10/100Mbps Fast Ethernet Adapter. [. . . ] the optional BOOT ROM device allows the diskless workstation to be connected to the network. Packing List: The adapter package should contain the following items: 1. One CD for Driver If any of these items are missing, please contact your reseller Installation: Hardware Installation : 1. Turn OFF the computer, unplug the power cord and open the computer case. 2. Pick a free PCI bus master expansion slot and remove the expansion slot cover. 3. Replace the computer cover and connect the network cable to the newly installed network adapter. Reconnect the computer's power cord and plug it into the power outlet. Configuration: The Zonet ZEN3200 is automatically configured when you power-on computer, In certain computer, however, you must modify BIOS by entering CMOS ETUP utility to enable PCI Device and map INTA to an appropriate address, Please refer to the system documentation for details on configuration the PCI SYSTEM BIOS. Driver Installation: Before you connect adapter to the network, you have to install the network driver first. The driver for each networking operating system is under a separate directory. [. . . ] Refer to the installation procedure provided by networking operating system (Options: Some adapters need to run SETUP Utility to enable Boot ROM function) 12-086-00518 Rev:01 [. . . ]