User manual ZONET ZEW1630 REV 00

[. . . ] If you are installing the driver under WinXP system, you need to select configuration tool. According to your needs, you can select MIMO Configuration Tool or Microsoft Zero Configuration Tool, and then click next. If you select Microsoft Zero Configuration Tool, please refer to 2. 3 Zero Configuration Service. Figure 2-3 5. Select Optimize for WiFi mode or Optimize for performance mode then click next Figure 2-4 6. [. . . ] If user wants to connect to other AP, just double click on the intended AP to make connection c. If the intended network has encryption "Not Use", RaConfig will bring up the security page and let user input the appropriate information to make the connection. Please refer to Chapter 4 to see how to fill the security information. Indicate connection status, the connected network's SSID will show up here 4. Issue a rescan command to update information on surrounding wireless network 5. It will bring up profile page and save user's setting to a new profile. 3. 3. 1 ADD/EDIT Profile a. SSID: User can key in the intended SSID name or use pull down menu to select from available APs 3. Power Save Mode: Choose from CAM (Constantly Awake Mode) or Power Saving Mode. There is a check box for AC power when CAM is checked, the wireless LAN card will stay full power when AC power cord is plug into power outlet 4. In addition to that, the channel and Ad hoc 13 wireless mode field will be available for setup in ad-hoc mode 5. TX Power: Transmit power, the amount of power used by a radio transceiver to send the signal out. Preamble: Under Ad-hoc mode, user can choose Auto, Long, or Short by pull down menu 7. Ad hoc wireless mode: Will be available for set up in Ad-hoc mode by pull down menu 8. RTS Threshold: User can adjust the RTS threshold number by pull down menu or key in the value directly. The default value is 2347 Fragment Threshold: User can adjust the FRG threshold number by sliding the bar or key in the value directly. Channel: Will be available for set up in Ad-hoc mode by pull down menu b. Authentication & Security 3. 4 Statistics Statistics page shows the detail counter information based on 802. 11 MIB counters. This page translates MIB counters into a format easier for user to understand. Reset counters to zero 14 3. 5 Advance Figure 3-6 shows the advance setting page of RaConfig Figure 3-6 1. Wireless mode: There are 802. 11B only, 802. 11 B/G mixed, 802. 11A only, 802. 11 A/B/G mixed, and 802. 11G only modes are supported 2. DHCP is used for Dynamic IP Addressing and requires a dedicated DHCP server on the network. ESSID An Infrastructure configuration could also support roaming capability for mobile workers. [. . . ] Control information about each device is maintained in a structure known as a management information block. Static IP Addressing A method of assigning IP addresses to clients on the network. In networks with Static IP address, the network administrator manually assigns an IP address to each computer. Once a Static IP address is assigned, a computer uses the same IP address every time it reboots and logs on to the network, unless it is manually changed. [. . . ]